GE-LM-20: Versatile Medium-Capacity Tail Lift for Trucks and Trailers – Up to 2000kg Lift Capacity

Description Medium-Capacity Tail Lift for Trucks and Trailers – Up to 2000kg Lift Capacity The GE-LM.20 is an extremely versatile medium-capacity tail lift, suitable for commercial trucks above 7.5T GVW, trailers, and semi-trailers. This powerful 4-cylinder lift is available with reinforced steel platforms or lightweight aluminium platforms up to 2250 mm. Longer platforms are available in combination with lift type GE-LM.30. Special applications are available: lifts for truck-trailer combinations with draw-bar (GE-LV), adaptations for trailer-coupling mounted between the chassis beams (arm LMK), for very short overhang (GE-LMP), and for tipper vehicles (GE-KA). A best-seller in the medium-duty capacity range. Powerful, stable 4-cylinder tail lift for 1500-2000 kg lift capacity. Maximum platform depth 2000 mm. Wedged platform. Level ride with an automatic tilt at ground level. Adjustable platform orientation. A very versatile lift is available with a large choice of value-adding options and extra equipment. Lift frame in hot-dip zinc plated or “galvanized” finish. Best possible protection against corrosion [OAT104]. Characteristics: PLATFORM Light-weight aluminium platform, or heavy-duty steel platform Aluminium platform with profiles oriented in a longitudinal direction [type V…], and a cross-milled anti-slip protection pattern Synthetic rollers for the contact between the platform and the ground Maximum platform depth: 2450 mm. (Longer platforms possible on GE-LM.30) FUNCTIONAL & MECHANICAL CHARACTERISTICS Conical/wedge platform. Level ride with an automatic tilt at ground level Platform tilt adjustable at any position from the exterior controls HYDRAULIC CHARACTERISTICS 2 lift cylinders for maximum platform stability 2 tilt cylinders with spring-assisted platform opening Electrical safety valves on all cylinders Manual emergency operation on all electro valves Cylinder piston rods in hard-chromed stainless steel Cylinders equipped with rubber gaiters and lubrication Pump unit 12V or 24V DC, accessible on 5 sides for easy maintenance ELECTRICAL CHARACTERISTICS Control box with battery disconnect switch, joystick control and change-over switch [OAE030.BT.0] Without battery disconnect switch: dual toggle-switch control box supplied loose [OAE048.0] Electrical controls without sensitive electronic components in basic configuration Safe exterior controls with compulsory 2-hand operation Electric motor with thermal cut-out fuse FITTING Bolt-on mounting plates for quick and easy fitting [OAM010] Fixed 3-piece bumper bar available as an option [OAF100.ST] FINISH & MAINTENANCE Low-maintenance bearings in all articulation points, plus grease nipples Lift frame in hot-dip zinc plated or “galvanised” finish. Best possible protection against corrosion [OAT104]. Alu platform or platform sections in natural finish Steel platforms to 2000 mm shotblasted and KTL epoxy primed, or in zinc primer at the discretion of Gilani Engineering. Steel platforms > 2000 mm in zinc primer.