Crown Audio CTs 4200 4 Channel Power Amplifier by HARMAN- 180 Watts per Channel into 8 Ohms – Refurbished

Reconditioned and/or Refurbished Product Notice: These goods have been reconditioned, rebuilt, or remade, as the case may be and no guarantee or warranty of such goods will be honoured or fulfilled by any official or licensed importer of such goods. However, any warranty claims will be covered by The Computer Emporium cc, in accordance with our Returns Policy. Please Note: – This product may or may not be in its original packaging – This product may or may not come with original parts and accessories – There may or may not be minor signs of wear and tear on the device 12 Months Limited Warranty (excludes Malicious Damage & Power Surge) Overview The Crown-Audio CTs 4200 is a 4-channel power amplifier housed in a 2RU rack, offering 190 watts per channel at 8 ohms, designed for fixed installation use. This amplifier features multiple simultaneous channel operation modes, 70 volt and 100 volt support, a switching power supply, and a variable speed fan cooling system. There is a comprehensive set of front panel indicators for each channel, along with advanced, well-designed thermal protection and fault isolation circuitry. The rear panel offers individual channel level trim controls, and 4-position operating mode switches. The CTs 4200 offers a progressive design and advanced features for a moderate price per channel, and represents a viable solution for budget-conscious commercial, theatrical, educational, and houses of worship installations. 4-channel installation power amplifier in 3 RU rackmount enclosure with 180W of power per channel at 8 ohms Crown switching power supply for reduced weight Selectable constant voltage 70V/100V or 4/8 ohm low impedance operation per channel pair with dedicated 4-position switches Multi Mode output topology allows for simultaneous dual and bridged operation FIT(Fault Isolation Topology) circuitry isolates faulty channels; adjacent channels remain unaffected TLC thermal protection circuitry engages internal channel compressor, dynamically reduces amplifier gain to reduce heat levels and prevent overheating Front-to-rear forced airflow cooling vents, continuously variable speed fan cooling Automatically inserted 35 Hz high-pass filter for channel pair in 70/100V operation Advanced protection circuitry includes guards against shorted outputs, open circuits, mismatched loads, general overheating, DC, under/over voltage, high frequency overloads and internal faults Comprehensive front panel indicator array includes individual channel LEDs for Bridge, Ready, Signal, Clip, Thermal and Fault; dedicated Power and Data indicators Blue power indicator LED flashes when amplifier shuts down during under/over voltage condition on AC mains Crown Audio CTs 4200 Specs Power Rating Dual, 4 Channels Driven: 260W @ 4 ohms (per channel) 180W @ 8 ohms (per channel) 220W @ 70V (per channel) Dual, 1 Channel Driven: 270W @ 4 ohms (per channel) 220W @ 8 ohms (per channel) 250W @ 70V (per channel) Bridge-Mono, 2 Channel Pairs Driven: 520W @ 8 ohms (per channel pair) 400W @ 16 ohms (per channel pair) 220W @ 100V (per channel pair) Bridge-Mono, 1 Channel Pair Driven: 560W @ 8 ohms (per channel pair) 440W @ 16 ohms (per channel pair) 250W @ 100V (per channel pair) Damping Factor 10 Hz – 400 Hz: >180 Input Sensitivity 1.4V Input Impedance 20 kOhms balanced (nominal) 10 kOhms unbalanced (nominal) Gain 4/8 ohm Operation: 20:1 (26 dB) 70V Operation: 50:1 (34 dB) 100V Operation: 71.4:1 (37 dB) Frequency Response 20 Hz – 20 kHz /-0.5 dB @ 1W Signal-to-Noise Ratio 100 dB unweighted (20 Hz – 20 kHz, below rated power) Total Harmonic Distortion (THD) <0.05% @1W, from 20 Hz – 20 kHz Input Connections 2 x Removable Phoenix Balanced Barrier Blocks Output Connectors 2 x 4-pole Terminal Strips with Touch-Proof Covers* *1 for every 2 channels Controls Front Panel 1 x Power Switch Controls (Rear) 4 x 21-position Rotary Channel Level Trim Controls (-70 – 0 dB) 2 x 4-position Dual/Bridge Mode Switches Indicators Front Panel: 2 x Yellow LED Bridge Mode Indicators 4 x Green LED Ready Indicators 4 x Green LED Input Signal Indicators 4 x Red LED Thermal Indicators 4 x Red LED Fault Indicators 1 x Yellow LED IQ Loop Data Indicator 1 x Blue LED Power Indicator Rear Panel: None Cooling Continuously Variable Speed Forced Air, Front to Back Airflow Power Consumption 58W, Idle, All Channels 4/8 ohm Mode* 77W, Idle, All Channels 70V Mode* *120 VAC Dimensions 19 x 3.5 x 16.25″ (483 x 89 x 413mm) Weight 27.8 lbs (12.5 kg) Specialties 4-channel Rackmount Installation Amplifier 4 Switchable Modes include 70 and 100V Operation Variable Speed Fan Cooling Eligible for next day delivery or collection   Free Delivery Available on Order From R2999  Hassle-Free Exchanges & Return for 30 Days   12-Month Limited Warranty.  Category: Audio Equipment Tags: Channel Power Amplifier, Crown Audio, Crown Audio CTs, Crown Audio CTs 4200 4 Channel Power Amplifier